First of all: this is a remake of the amazing: https://www.thingiverse.com/thing:4817279
I made the following changes:
the table now is bigger : 28 cm of diameter I used an ESP32 with WIFI I made it an Access Point you can access via AP and change: direction and speed the switch is round it is all fully enclosed with 18650 batteries that can be extracted and changes I know it is overkill using esp32, but it was there around doing nothing. the ESP has also a display which I am not using.
You can find also the *.ino file and the html.h one. I am not very good in HTML5 and css so if you can get it better let me know that I will update it.
Notes: You need a large plate for printing the top which is 28 cm of diameter. at the same time it is important to have a flexible plate otherwise it will be very difficult to take it out given the large surface that touches the bed. I suggest 4 perimeters, using for the external one 95% flow and lower speed, in this way you have an amazing smooth result.
this is a project you can find on thingiverse here: https://www.thingiverse.com/thing:4846512 this is a project you can find on Prusa here: https://www.prusaprinters.org/prints/65607-rotating-turntable-esp32-wifi-web-interface-28cm-d
about the WIFI:
- you will fine an open Access Point to connect: MyESP32AP
- then go with the browser to http://192.168.4.1 then you find a slider for the speed and a switch button for the direction.